ASIST Wrong Route Tool

IF YOU HAVE FOUND THIS PAGE IT IS UNDER CONSTRUCTION! :)

The aSIST Wrong Route Tool displays the headcode of the approaching train at preconfigured junctions along with its planned route.

In the event of a wrong route, the tool will generate both an audible and visual alarm.

The Wrong Route Tool can also be configured to include train approach alarms, crossing approach alarms, and a TRTS indication.

Data Feed

aSIST runs off of the plan contained within acumen.

The plan begins as the long term plan CIF file which is then updated with short term plan incremental CIFs.

On the day of operation, VSTPs are processed alongside other updates through TRUST (e.g. cancellations) and received through external sources such as DARWIN/CIS.

Initial Screen

Users are initially presented with the following screen.

To start the tool, click on the screen.

Note: The tool will remain open and running unless there is a connection failure such as a computer restart. Only on these occasions would the initial screen be seen.

Standard View

System Health

The bottom half of the interface includes a number of indicators of system health.

• The blinking dot next to SERVER LINK CONNECTED confirms the tool is connected to the server. If the dot is static then the server connection has been lost.
• The TD Lag indicates how old the data is. There should be minimal lag between a message being sent and then displayed within aSIST. The TD lag will typically be within 10 seconds.
• The Last Update displays the time the most recent data was received. This will most commonly update every 1-2 seconds.

If the system health indicators are not updating as expected, please see aSIST Support.

Routing Display

The Wrong Route Tool can display up to six different junctions.

Each junction is confined to its own box. For example, below is the display for New Cross Gate.

The tool displays the headcode of the next train approaching the junction.

The black arrow indicates the planned route or direction of that train.

Note: The boxes below the arrow and headcode have been reserved for additional functionality such as the option to mute the audible alarm in the event of diversions.

When the arrow is green, this means the route set is the same as the planned route; a correctly routed train.

If the route set is not the same as the planned route, an audible and visual warning is displayed. An example is seen below in the Wrong Route Set section.

A question mark will be displayed if aSIST has been unable to match a schedule or it is an unplanned service:

If multiple headcodes are displaying as unmatched, there may be an issue with the timetable information. Please see aSIST Support.

Wrong Route Set

If a wrong route is set an audible and visual alarm is generated.

The audible alarm reads the name of the signal at the junction.

In the example below, 9C21 has been incorrectly routed at Sydenham Junction.

The arrow has turned red to show this is incorrect and the headcode is also flashing red.

Note: The arrow will always point in the intended direction.

The audible alarm will sound once. The visual alert will continue until the train passes the junction or the route drops out following a time out.

Additional Tools

Train Approach

At configured locations, a train approach bell will sound.

For example the image below captures the train approach indication for 6M56 striking a pre-determined point on approach to Clapham Jn. The booked time is also displayed.

TRTS

At configured locations, a TRTS indication is displayed when the TRTS button is pushed.

For example, the image below indicates the TRTS has been pushed on Platform 3 at St Pancras.